Skip to content

Gas Fitter Rankin Park

Rankin Park Plumbing Co does gas fitting across Rankin Park: appliance installation, gas hot water connections, leak detection and repairs, all quoted up front. Ring (02) 4093 0558 or use the form below to book. The Rankin Park Plumbing Co home page lists drains, hot water and emergency work too.

Licensed plumbers and gas fitters · NSW Lic. 359278C

Last updated September 2026

Plumber working on a gas oven connection
Freestanding gas cooker connected in a kitchen

What does a gas fitter do?

Everything on the house side of the meter, each piece tested before sign-off:

  • Cooktop, oven, heater and BBQ connections
  • Gas hot water, whether a cylinder or an instantaneous unit
  • Pool heaters and their supply line
  • New gas runs, upgrades to old pipe, and disconnections
  • Leak detection, pressure testing and compliance certificates

Each job ends with the line tested and the paperwork in your hand, because gas work is not finished until it is proven tight.

Rankin Park Gas Fitting Services

Two pages carry the detail:

Gas Appliance Installation

Gas Leak Detection and Repair

Plumber beside a newly installed continuous-flow gas hot water unit

How do you spot a gas fault?

Watch for these:

  • A rotten-egg odour near an appliance or inside a cupboard
  • Burner flames that have turned floppy and yellow at the tips
  • A faint whistle at a fitting or where the pipe enters the house
  • An appliance that keeps cutting out, or a bill that climbs with no change in use

An indoor gas smell is urgent, and the gas leak page sets out the safety steps in order.

How the gas work runs

Every gas job follows these four steps:

  1. 01

    Ring or send the form

    Call (02) 4093 0558 or use the form to explain the fault. We ask enough to bring the right equipment the first time.

  2. 02

    A fixed price first

    A plumber inspects the job and names a fixed figure up front. Nothing gets started until you give the go-ahead.

  3. 03

    Test, fit and certify

    The line is isolated and pressure tested, the appliance goes on or the leak is sealed, and the run is proven tight before the gas returns.

  4. 04

    Covered for a year

    Every job carries our 365-day warranty on all work. If something we did isn't right, ring the same number.

What drives the price of gas fitting?

  • The pipe run A new appliance near the meter costs less than a line that has to travel the length of the house.
  • The appliance A cooktop swap takes less time than a pool heater needing its own gas run.
  • The existing pipe Old or undersized line may need upgrading before the new appliance can go on safely.
  • A weekend fault Work outside business hours carries a higher rate, told to you when you ring.

Gas work on an estate of family houses

A suburb of same-era houses

At the last census, 99.2 per cent of Rankin Park homes were separate houses, brick-veneer places built on the Cambridge Hills Estate through the 1970s and 1980s. Homes of one era share one generation of gas pipe, regulators and connectors.

Renovations move the gas point

Owner-occupiers updating a 1980s kitchen tend to change the layout, and a new cooktop in a new spot needs its supply rerouted. That rerouting is priced into the quote from the start.

Age shows in the fittings

Flexible connectors and appliance valves from that period have been in service for decades, so a new appliance is a good time to pressure test the whole line.

"We had an urgent gas problem that required immediate attention at our home…on a Friday afternoon. … Identified the issue, fixed and tested" Lee

When we're not the right call

the meter and the street service pipe are the distributor's property, and faults on them are reported on the distributor's emergency line. Our work starts at the outlet of the meter.
Gas fitter at work on a kitchen oven

Gas questions people ask before booking

Do I need a licensed gas fitter to connect a new cooktop?

Yes. Connecting any gas appliance is licensed work in NSW. The fitter makes the connection, tests the line for leaks and completes the compliance paperwork before you light it.

What should I do if I can smell gas in my home?

Get everyone outside without touching light switches or anything electrical, and ring the gas network's emergency number from the street. When they have made it safe, we trace the fault in your own pipework and repair it.

Can you convert my Rankin Park home from electric hot water to gas?

We can, if there is a gas main in your street. The job covers the new unit, the gas run and the connections, and the price is on paper before anything starts. Gas, electric, solar and heat pump are compared on the hot water page.

How long does a gas appliance installation take?

A like-for-like swap on an existing gas point is a short job: old appliance off, new one on, line tested and signed off. New pipe across the house adds time, and the quote tells you how much before you commit.

Need a plumber? Call or send the form

Call (02) 4093 0558 or send the form below. Available 24/7, you see a fixed figure ahead of any work, and every job carries our 365-day warranty on all work.

Call (02) 4093 0558

Request a callback

Leave a name and number and a plumber will ring you back.

We use your details only to call you back about this job. See our privacy policy.

Call (02) 4093 0558 Get a quote